Wed Apr 13 07:11:02 CDT 2022
Oversize & Overweight Permits in Oklahoma: Key Regulations
Important: We are not a permit service and we do not arrange permits for carriers. All information provided below is for information purpose only. Always read permits and provisions carefully as we cannot guarantee the accuracy of information provided below.
When it comes to transporting heavy haul – oversize or overweight loads – in Oklahoma, being aware of the vehicle dimensions, weight limits, and permit requirements is important to avoid issues when transiting your heavy haul. Here are details:
Permit Validity & Operating Hours
- Oversize permits are valid for three days and must be obtained before entering Oklahoma.
- Operating times are from 30 minutes before sunrise to 30 minutes after sunset, seven days a week.
- Overweight permits allow continuous travel but must be requested when applying.
Restricted Travel & Holiday Closures
- Restricted on Interstates in Cleveland and Tulsa counties during peak hours (7–9 AM and 3:30–6:30 PM, weekdays).
- No permit travel is allowed on major holidays.
Oklahoma Turnpikes & Legal Dimensions
- Loads up to 9’6” wide don’t require a Pike Pass.
- Wider loads (up to 11’6” or 13’6” on Cherokee Turnpike) require a Pike Pass reference.
- Maximum weight on turnpikes is 108,000 lbs.
Legal Dimensions for Heavy Haul Trucks:
- Length: 59’6” on U.S. Defense Highways; 53’ on other roads.
- Width: 8’6” (8’ on roads narrower than 20’).
- Height: 13’6”.
- Weight Limits: 80,000 lbs (Interstate), 90,000 lbs (non-Interstate).
Routine Permit Limits & Escort Requirements
- Width: Up to 16’.
- Height: Varies by route.
- Weight:
- Single axle: 20,000 lbs
- Tandem axle: 40,000 lbs (with proper spacing)
- Steer axle: 15,000 lbs (additional weight requires bridge approval)
Escort Requirements for Oversize Shipments
- Length:
- Over 80’ (2-lane roads) – 1 escort
- Over 100’ (2-lane roads) – 2 escorts
- Width:
- Over 12’ – 1 escort
- Over 14’ (2-lane) or 16’ (multi-lane) – 2 escorts
- Height: Over 15’8” – 2 escorts (plus utility/railroad notifications)
Safety & Compliance
- Marking & Signage:
- “Oversize Load” signs are required on the front and rear of the vehicle.
- Flags must mark the widest points and any overhang exceeding 4’.
- Special Cases: Dozers with blades over 12’ wide can’t travel more than 50 miles without blade removal.
While transporting heavy haul, proper route planning, understanding of safety regulations, and obtaining the appropriate single-trip permits, are important to successful logistics management.